If you press and hold any of these switches at startup, system information including software version and the serial number of the device will appear
The ground balance value during ground balancing and the target ID during searching instantly appears on the numeric display located on the handle. Th
The menu screen allows you to access all the FORS Gold settings. You can go to the menu screen by pressing one of the up/down/+/- switches while on th
You can customize ID Masking according to your needs. Each mode has its own default ID Masking value in the menu. When you change the mode, the ID Mas
The brightness level of the LCD panel on the system box aects power consumption a lot. Therefore, the backlight illuminates during menu access and gr
IMPORTANT DETAILS ABOUT MENU USAGE:*If no button is pressed for a few seconds after accessing the menu, the device will go back to the main screen. If
GENERAL SEARCH MODE (GEN):Sometimes referred to as the ''All Metal'' mode, this is the deepest mode of the device. Dierent than t
Metal detectors work on the principle of conductivity and all metals are conductive. On the other hand, soil itself has a certain degree of conductive
One of the following may happen as a result of improper ground balancing: -The device gives a signal whe
After the ground balance button is released, the device will work in the General Search mode and the ground balance value will remain on screen for a
NOKTA DETECTORSINTRODUCTIONFORS / Page 1Thank you for choosing and purchasing our Nokta FORS Gold detector.FORS Gold, developed by Nokta's expert
4. Continue the above process until the sound is eliminated. If the sound is not completely eliminated, then you can fine tune. For fine tuning, follo
GROUND BALANCE VALUE:The ground balance value indicates the type of ground. Some typical ground types are as follows:0-25 Wet salt water or w
Adjusting these two settings correctly is critical for the device to work at its best performance and without noise. It is possible to obtain an avera
As mentioned before, Target ID is a 2-digit number produced by the detector and it gives you an idea about what the target may be. The number is displ
ROCK IRONBrown Area (Target ID: 0-16): Highly mineralized soil and positive or negative hot rocks.Blue Area (Target ID: 16-40): Ferrous metals (Gold u
12Pinpointing is to determine the center or the exact location of a detected target.FORS Gold operates on the principle of motion. This means that you
The device gives an estimated depth reading based on signal strength in the pinpoint mode. When the pinpoint button is pressed and the target is appro
Magnetic Mineralization level ranges from 0-99 and is displayed in the Magnetic Mineralization Indicator on the right side of the main screen. This me
In discrimination modes, positive hot rocks will give a typical metal sound again. Negative hot rocks will not give any sound in these modes (except f
METALS UNDER HOT ROCKSNo matter what the reason is, a well adjusted FORS Gold will increase your chance of finding metals under hot rocks. The combine
TABLE OF CONTENTSWARNINGS ...
At the bottom of the LCD panel, on the main screen, messages will appear if any. If there is no message, the present search mode name will be displaye
The technical settings of the device (Mode, Ground Balance, Sensitivity, Threshold, and ID Masking, Frequency) come with their factory default values
Operating PrincipleOperating FrequencyMetal IdentificationSearch ModesAudio FrequenciesAudio DiscriminationGround BalanceGround TrackingPinpointFreque
WARNINGS LEGAL WARNINGS► When using the device, comply with all applicable laws and regulations. Do not use the device in private premises, histor
PARTS and ASSEMBLY127743568107Attach the right/left armrest components to the S-rod with the bolts and nuts as seen in the picture. Do not tighten the
1132324PARTS and ASSEMBLY1)To attach the telescopic shaft to the S-rod, first loosen the twist lock. 2)By holding the metal pin pressed, insert the te
CORRECT WAY OF HOLDINGCORRECT WAY OF SWEEPINGShaft height is wrong.It is very important to adjust the shaft to your height correctly to be able to sea
The device comes with 4 AA Alkaline batteries.Slide and remove the battery compartment cover by pressing the latch. Insert the batteries paying attent
15 7 6432(1) POWER SWITCH:To turn on the device, press the power switch to (1) position. The startup tone will be heard and after the Nokta logo is di
Kommentare zu diesen Handbüchern