Nokta-detectors Fors CoRe Bedienungsanleitung

152346TargetIDGeneral Search7645GENIf you press and hold any of these switches at startup, system information including software version and the seria

123451 2354TargetDepth7628GroundBalancePump The Coil2060The ground balance value during ground balancing and the target ID during searching instantly

The menu screen allows you to access all the FORS CoRe settings. You can go to the menu screen by pressing one of the up/down/+/- switches while on th

You can customize ID Masking according to your needs. Each mode has its own default ID Masking value in the menu. When you change the mode, the ID Mas

The brightness level of the LCD panel on the system box aects power consumption a lot. Therefore, the backlight illuminates during menu access and gr

IMPORTANT DETAILS ABOUT MENU USAGE:* If no button is pressed for a few seconds after accessing the menu, the device will go back to the main screen. I

GENERAL SEARCH MODE (GEN):Sometimes referred to as the ''All Metal'' mode, this is the deepest mode of the device. Dierent than t

Metal detectors work on the principle of conductivity and all metals are conductive. On the other hand, soil itself has a certain degree of conductive

One of the following may happen as a result of improper ground balancing: -The device gives a signal whe

One of the following may happen as a result of improper ground balancing: -The device gives a signal whe

Thank you for choosing and purchasing our Nokta FORS CoRe detector.FORS CoRe, developed by Nokta's expert engineering team experienced in metal d

4. Continue the above process until the sound is eliminated. If the sound is not completely eliminated, then you can fine tune. For fine tuning, follo

GROUND BALANCE VALUE:The ground balance value indicates the type of ground. Some typical ground types are as follows:0-25 Wet salt water or w

Adjusting these two settings correctly is critical for the device to work at its best performance and without noise. It is possible to obtain an avera

Hot Rocks and Mineralized SoilsHot rocksIron rocksSalty and alkali soils 0-5 / 95-995-2525-35Non-ferrous MetalsGold nuggets and coinsSilver and leadBr

Brown Area: Hot rocks Blue Area: Ferrous metals, iron rocks, salty and alkali soilsYellow Area: Gold, folio, soda cans, pull-tabs, some coins etc.Red

Pinpointing is to determine the center or the exact location of a detected target.FORS CoRe operates on the principle of motion. This means that you m

The device gives an estimated depth reading based on signal strength in the pinpoint mode. When the pinpoint button is pressed and the target is appro

Magnetic Mineralization level ranges from 0-99 and is displayed in the Magnetic Mineralization Indicator on the right side of the main screen. This me

In discrimination modes, positive hot rocks will give a typical metal sound again. Negative hot rocks will not give any sound in these modes (except f

In reality a simple principle can save you a lot of time: ''If the target encountered is not a rock, it can be metal''.The key to

TABLE OF CONTENTSFORS / Page 2www.noktadetectors.comNOKTA DETECTORSWARNINGS ...

At the bottom of the LCD panel, on the main screen, messages will appear if any. If there is no message, the present search mode name will be displaye

The technical settings of the device (Mode, Ground Balance, Sensitivity, Threshold, and ID Masking, Frequency) come with their factory default values

Operating PrincipleOperating FrequencyMetal IdentificationSearch ModesAudio FrequenciesAudio DiscriminationGround BalanceGround TrackingPinpointFreque

LEGAL WARNINGS► When using the device, comply with all applicable laws and regulations. Do not use the device in private premises, historic sites

PARTS and ASSEMBLY127743568107Attach the right/left armrest components to the S-rod with the bolts and nuts as seen in the picture. Do not tighten the

1132324PARTS and ASSEMBLY1)To attach the telescopic shaft to the S-rod, first loosen the twist lock. 2)By holding the metal pin pressed, insert the te

CORRECT WAY OF HOLDINGCORRECT WAY OF SWEEPINGShaft height is wrong.It is very important to adjust the shaft to your height correctly to be able to sea

TargetIDGeneral Search7645GENROCK IRONTargetIDGeneral Search7645GENTargetIDLow Battery00- -ROCK IRONTargetIDGeneral Search7645GENThe device comes with

15 7 6432DEVICE INTRODUCTION(1) POWER SWITCH:To turn on the device, press the power switch to (1) position. The startup tone will be heard and after t